| [target.thumbv7m-none-eabi] |
| # uncomment this to make `cargo run` execute programs on QEMU |
| runner = "qemu-system-arm -cpu cortex-m3 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel" |
| |
| [target.thumbv6m-none-eabi] |
| # uncomment this to make `cargo run` execute programs on QEMU |
| # For now, we use cortex-m3 instead of cortex-m0 which are not supported by QEMU |
| runner = "qemu-system-arm -cpu cortex-m3 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel" |
| |
| [target.'cfg(all(target_arch = "arm", target_os = "none"))'] |
| # uncomment ONE of these three option to make `cargo run` start a GDB session |
| # which option to pick depends on your system |
| # runner = "arm-none-eabi-gdb -q -x openocd.gdb" |
| # runner = "gdb-multiarch -q -x openocd.gdb" |
| # runner = "gdb -q -x openocd.gdb" |
| |
| rustflags = [ |
| # LLD (shipped with the Rust toolchain) is used as the default linker |
| "-C", "link-arg=-Tlink.x", |
| |
| # if you run into problems with LLD switch to the GNU linker by commenting out |
| # this line |
| # "-C", "linker=arm-none-eabi-ld", |
| |
| # if you need to link to pre-compiled C libraries provided by a C toolchain |
| # use GCC as the linker by commenting out both lines above and then |
| # uncommenting the three lines below |
| # "-C", "linker=arm-none-eabi-gcc", |
| # "-C", "link-arg=-Wl,-Tlink.x", |
| # "-C", "link-arg=-nostartfiles", |
| ] |