zircon/system/banjo/ddk.protocol.gpio/gpio.banjo

// Copyright 2018 The Fuchsia Authors. All rights reserved.
// Use of this source code is governed by a BSD-style license that can be
// found in the LICENSE file.

library ddk.protocol.gpio;

using zx;

/// Flags for `ConfigIn`.
const uint32 GPIO_PULL_DOWN = 0x0;
const uint32 GPIO_PULL_UP = 0x1;
const uint32 GPIO_NO_PULL = 0x2;
const uint32 GPIO_PULL_MASK = 0x3;

/// Values for `SetPolarity`.
enum GpioPolarity : uint32 {
    LOW = 0x0;
    HIGH = 0x1;
};

[Layout = "ddk-protocol"]
protocol Gpio {
    /// Configures a GPIO for input.
    ConfigIn(uint32 flags) -> (zx.status s);
    /// Configures a GPIO for output.
    ConfigOut(uint8 initial_value) -> (zx.status s);
    /// Configures the GPIO pin for an alternate function (I2C, SPI, etc)
    /// the interpretation of "function" is platform dependent.
    SetAltFunction(uint64 function) -> (zx.status s);
    /// Reads the current value of a GPIO (0 or 1).
    Read()-> (zx.status s, uint8 value);
    /// Sets the current value of the GPIO (any non-zero value maps to 1).
    Write(uint8 value) -> (zx.status s);
    /// Gets an interrupt object pertaining to a particular GPIO pin.
    GetInterrupt(uint32 flags) -> (zx.status s, handle<interrupt> irq);
    /// Release the interrupt.
    ReleaseInterrupt()-> (zx.status s);
    /// Set GPIO polarity.
    SetPolarity(GpioPolarity polarity) -> (zx.status s);
};