| # |
| # Simnet Network Layout: Two HANs with shared gateways implemented on host |
| # |
| # This simnet configuration defines two HANs, each with its own WiFi and Thread networks. |
| # Both HANs contain a single Weave device connected to the respective WiFi/Thread networks. |
| # The HANs also contain separate Gateway nodes that are implemented, in unison, by the |
| # host (i.e. the host acts as both Gateways simultaneously). The gateways use the host's |
| # default interface (typically eth0) as their outside interface allowing the HANs to |
| # access the internet if the host has internet access. |
| # |
| # Note: In order for this configuration to work, the two Gateway nodes must use distinct |
| # IPv4 subnets on their inside interfaces, even though in a real scenario they could use |
| # the same subnet. |
| # |
| |
| # |
| # Copyright (c) 2015-2017 Nest Labs, Inc. |
| # All rights reserved. |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| |
| #=============================================================================== |
| # HAN-1 |
| #=============================================================================== |
| |
| WiFiNetwork( |
| name = 'han-1-wifi', |
| ) |
| |
| ThreadNetwork( |
| name = 'han-1-thread', |
| meshLocalPrefix = 'fd24:2424:2424::/64' |
| ) |
| |
| # Gateway in HAN-1 implemented on host, with outside access via host's default interface. |
| Gateway( |
| name = 'han-1-gw', |
| outsideNetwork = None, |
| outsideInterface = 'host-default', |
| useHost = True, |
| insideNetwork = 'han-1-wifi', |
| insideIP4Subnet = '192.168.168.0/24', |
| isIP4DefaultGateway = True |
| ) |
| |
| # Weave device in HAN-1 connected to HAN-1 WiFi and Thread networks |
| WeaveDevice( |
| name = 'han-1-dev', |
| weaveNodeId = 1, |
| weaveFabricId = 1, |
| wifiNetwork = 'han-1-wifi', |
| threadNetwork = 'han-1-thread' |
| ) |
| |
| #=============================================================================== |
| # HAN-2 |
| #=============================================================================== |
| |
| WiFiNetwork( |
| name = 'han-2-wifi', |
| ) |
| |
| ThreadNetwork( |
| name = 'han-2-thread', |
| meshLocalPrefix = 'fd42:4242:4242::/64' |
| ) |
| |
| # Gateway in HAN-2 implemented on host, with outside access via host's default interface. |
| Gateway( |
| name = 'han-2-gw', |
| outsideNetwork = None, |
| outsideInterface = 'host-default', |
| useHost = True, |
| insideNetwork = 'han-2-wifi', |
| insideIP4Subnet = '192.168.167.0/24', |
| isIP4DefaultGateway = True |
| ) |
| |
| # Weave device in HAN-2 connected to HAN-2 WiFi and Thread networks |
| WeaveDevice( |
| name = 'han-2-dev', |
| weaveNodeId = 2, |
| weaveFabricId = 2, |
| wifiNetwork = 'han-2-wifi', |
| threadNetwork = 'han-2-thread' |
| ) |