blob: 532f8b290835c37477875f7a5cafe944b4658bd1 [file] [log] [blame]
/**
* \file
*
* \brief Status code definitions.
*
* This file defines various status codes returned by functions,
* indicating success or failure as well as what kind of failure.
*
* Copyright (c) 2012-2018 Microchip Technology Inc. and its subsidiaries.
*
* \asf_license_start
*
* \page License
*
* Subject to your compliance with these terms, you may use Microchip
* software and any derivatives exclusively with Microchip products.
* It is your responsibility to comply with third party license terms applicable
* to your use of third party software (including open source software) that
* may accompany Microchip software.
*
* THIS SOFTWARE IS SUPPLIED BY MICROCHIP "AS IS". NO WARRANTIES,
* WHETHER EXPRESS, IMPLIED OR STATUTORY, APPLY TO THIS SOFTWARE,
* INCLUDING ANY IMPLIED WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY,
* AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT WILL MICROCHIP BE
* LIABLE FOR ANY INDIRECT, SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL
* LOSS, DAMAGE, COST OR EXPENSE OF ANY KIND WHATSOEVER RELATED TO THE
* SOFTWARE, HOWEVER CAUSED, EVEN IF MICROCHIP HAS BEEN ADVISED OF THE
* POSSIBILITY OR THE DAMAGES ARE FORESEEABLE. TO THE FULLEST EXTENT
* ALLOWED BY LAW, MICROCHIP'S TOTAL LIABILITY ON ALL CLAIMS IN ANY WAY
* RELATED TO THIS SOFTWARE WILL NOT EXCEED THE AMOUNT OF FEES, IF ANY,
* THAT YOU HAVE PAID DIRECTLY TO MICROCHIP FOR THIS SOFTWARE.
*
* \asf_license_stop
*
*/
/*
* Support and FAQ: visit <a href="https://www.microchip.com/support/">Microchip Support</a>
*/
#ifndef STATUS_CODES_H_INCLUDED
#define STATUS_CODES_H_INCLUDED
#include <stdint.h>
/**
* \defgroup group_sam0_utils_status_codes Status Codes
*
* \ingroup group_sam0_utils
*
* @{
*/
/** Mask to retrieve the error category of a status code. */
#define STATUS_CATEGORY_MASK 0xF0
/** Mask to retrieve the error code within the category of a status code. */
#define STATUS_ERROR_MASK 0x0F
/** Status code error categories. */
enum status_categories {
STATUS_CATEGORY_OK = 0x00,
STATUS_CATEGORY_COMMON = 0x10,
STATUS_CATEGORY_ANALOG = 0x30,
STATUS_CATEGORY_COM = 0x40,
STATUS_CATEGORY_IO = 0x50,
};
/**
* Status code that may be returned by shell commands and protocol
* implementations.
*
* \note Any change to these status codes and the corresponding
* message strings is strictly forbidden. New codes can be added,
* however, but make sure that any message string tables are updated
* at the same time.
*/
enum status_code {
STATUS_OK = STATUS_CATEGORY_OK | 0x00,
STATUS_VALID_DATA = STATUS_CATEGORY_OK | 0x01,
STATUS_NO_CHANGE = STATUS_CATEGORY_OK | 0x02,
STATUS_ABORTED = STATUS_CATEGORY_OK | 0x04,
STATUS_BUSY = STATUS_CATEGORY_OK | 0x05,
STATUS_SUSPEND = STATUS_CATEGORY_OK | 0x06,
STATUS_ERR_IO = STATUS_CATEGORY_COMMON | 0x00,
STATUS_ERR_REQ_FLUSHED = STATUS_CATEGORY_COMMON | 0x01,
STATUS_ERR_TIMEOUT = STATUS_CATEGORY_COMMON | 0x02,
STATUS_ERR_BAD_DATA = STATUS_CATEGORY_COMMON | 0x03,
STATUS_ERR_NOT_FOUND = STATUS_CATEGORY_COMMON | 0x04,
STATUS_ERR_UNSUPPORTED_DEV = STATUS_CATEGORY_COMMON | 0x05,
STATUS_ERR_NO_MEMORY = STATUS_CATEGORY_COMMON | 0x06,
STATUS_ERR_INVALID_ARG = STATUS_CATEGORY_COMMON | 0x07,
STATUS_ERR_BAD_ADDRESS = STATUS_CATEGORY_COMMON | 0x08,
STATUS_ERR_BAD_FORMAT = STATUS_CATEGORY_COMMON | 0x0A,
STATUS_ERR_BAD_FRQ = STATUS_CATEGORY_COMMON | 0x0B,
STATUS_ERR_DENIED = STATUS_CATEGORY_COMMON | 0x0c,
STATUS_ERR_ALREADY_INITIALIZED = STATUS_CATEGORY_COMMON | 0x0d,
STATUS_ERR_OVERFLOW = STATUS_CATEGORY_COMMON | 0x0e,
STATUS_ERR_NOT_INITIALIZED = STATUS_CATEGORY_COMMON | 0x0f,
STATUS_ERR_SAMPLERATE_UNAVAILABLE = STATUS_CATEGORY_ANALOG | 0x00,
STATUS_ERR_RESOLUTION_UNAVAILABLE = STATUS_CATEGORY_ANALOG | 0x01,
STATUS_ERR_BAUDRATE_UNAVAILABLE = STATUS_CATEGORY_COM | 0x00,
STATUS_ERR_PACKET_COLLISION = STATUS_CATEGORY_COM | 0x01,
STATUS_ERR_PROTOCOL = STATUS_CATEGORY_COM | 0x02,
STATUS_ERR_PIN_MUX_INVALID = STATUS_CATEGORY_IO | 0x00,
};
typedef enum status_code status_code_genare_t;
/**
Status codes used by MAC stack.
*/
enum status_code_wireless {
//STATUS_OK = 0, //!< Success
ERR_IO_ERROR = -1, //!< I/O error
ERR_FLUSHED = -2, //!< Request flushed from queue
ERR_TIMEOUT = -3, //!< Operation timed out
ERR_BAD_DATA = -4, //!< Data integrity check failed
ERR_PROTOCOL = -5, //!< Protocol error
ERR_UNSUPPORTED_DEV = -6, //!< Unsupported device
ERR_NO_MEMORY = -7, //!< Insufficient memory
ERR_INVALID_ARG = -8, //!< Invalid argument
ERR_BAD_ADDRESS = -9, //!< Bad address
ERR_BUSY = -10, //!< Resource is busy
ERR_BAD_FORMAT = -11, //!< Data format not recognized
ERR_NO_TIMER = -12, //!< No timer available
ERR_TIMER_ALREADY_RUNNING = -13, //!< Timer already running
ERR_TIMER_NOT_RUNNING = -14, //!< Timer not running
/**
* \brief Operation in progress
*
* This status code is for driver-internal use when an operation
* is currently being performed.
*
* \note Drivers should never return this status code to any
* callers. It is strictly for internal use.
*/
OPERATION_IN_PROGRESS = -128,
};
typedef enum status_code_wireless status_code_t;
/** @} */
#endif /* STATUS_CODES_H_INCLUDED */