The vmm
app enables booting a guest operating system using the Zircon hypervisor. The hypervisor and VMM are collectively referred to as “Machina”.
These instructions will guide you through creating minimal Zircon and Linux guests. For instructions on building a more comprehensive Linux guest system see the debian_guest package.
These instructions assume a general familiarity with how to netboot the target device.
Configure, build, and boot the guest package as follows:
fx set core.${ARCH} --with-base //src/virtualization fx build
Where ${ARCH}
is one of x64
or arm64
.
(Googlers: You don't need to do this, the Linux images are downloaded from CIPD by jiri.)
The linux_guest
package expects the Linux kernel binaries to be in prebuilt/virtualization/packages/linux_guest
. You should create them before running fx build
by running the following scripts:
./src/virtualization/packages/linux_guest/mklinux.sh \ -l /tmp/linux/source \ -o prebuilt/virtualization/packages/linux_guest/images/${ARCH}/Image \ -b machina-4.18 \ ${ARCH} ./src/virtualization/packages/linux_guest/mksysroot.sh \ -o prebuilt/virtualization/packages/linux_guest/images/${ARCH}/disk.img \ -d /tmp/toybox \ -s /tmp/dash \ -u \ ${ARCH}
Note: -b
specifies the branch of zircon_guest
to use. You can modify this value if you need a different version or omit it to use a local version.
After netbooting the target device, to run Zircon:
guest launch zircon_guest
Likewise, to launch a Linux guest:
guest launch linux_guest
Running a guest on QEMU on x64 requires kvm (i.e. pass -k
to fx qemu
):
fx qemu -k
You may also need to enable nested KVM on your host machine. The following instructions assume a Linux host machine with an Intel processor.
To check whether nested virtualization is enabled, run the following command:
cat /sys/module/kvm_intel/parameters/nested
An output of Y
indicates nested virtualization is enabled, 0
or N
indicates not enabled.
To enable nested virtualization until the next reboot:
modprobe -r kvm_intel modprobe kvm_intel nested=1
To make the change permanent add the following line to /etc/modprobe.d/kvm.conf
:
options kvm_intel nested=1
Running an arm64 guest on QEMU requires either using GICv2 (pass -G 2
).
fx qemu -G 2
Or using a more recent version of QEMU (try 2.12.0). Older versions of QEMU do not correctly emulate GICv3 when running with multiple guest VCPUs.
fx qemu -q /path/to/recent/qemu/aarch64-softmmu ... guest launch (linux_guest|zircon_guest)
To run from Workstation, configure the guest package as follows:
fx set workstation.x64 --with-base //src/virtualization
After booting the guest packages can be launched from the system launcher as linux_guest
and zircon_guest
.
Machina has a set of integration tests that launch Zircon and Debian guests to test the VMM, hypervisor, and each of the virtio devices. To run the tests:
fx set core.${ARCH} --with-base //src/virtualization fx run-test guest_integration_tests
Guest systems can be configured by including a config file inside the guest package:
{ "type": "object", "properties": { "kernel": { "type": "string" }, "ramdisk": { "type": "string" }, "block": { "type": "string" }, "cmdline": { "type": "string" } } }