| Long: range |
| Short: r |
| Help: Retrieve only the bytes within RANGE |
| Arg: <range> |
| Protocols: HTTP FTP SFTP FILE |
| --- |
| Retrieve a byte range (i.e. a partial document) from an HTTP/1.1, FTP or SFTP |
| server or a local FILE. Ranges can be specified in a number of ways. |
| .RS |
| .TP 10 |
| .B 0-499 |
| specifies the first 500 bytes |
| .TP |
| .B 500-999 |
| specifies the second 500 bytes |
| .TP |
| .B -500 |
| specifies the last 500 bytes |
| .TP |
| .B 9500- |
| specifies the bytes from offset 9500 and forward |
| .TP |
| .B 0-0,-1 |
| specifies the first and last byte only(*)(HTTP) |
| .TP |
| .B 100-199,500-599 |
| specifies two separate 100-byte ranges(*) (HTTP) |
| .RE |
| .IP |
| (*) = NOTE that this will cause the server to reply with a multipart |
| response! |
| |
| Only digit characters (0-9) are valid in the 'start' and 'stop' fields of the |
| \&'start-stop' range syntax. If a non-digit character is given in the range, |
| the server's response will be unspecified, depending on the server's |
| configuration. |
| |
| You should also be aware that many HTTP/1.1 servers do not have this feature |
| enabled, so that when you attempt to get a range, you'll instead get the whole |
| document. |
| |
| FTP and SFTP range downloads only support the simple 'start-stop' syntax |
| (optionally with one of the numbers omitted). FTP use depends on the extended |
| FTP command SIZE. |
| |
| If this option is used several times, the last one will be used. |
