# Reported 93/05/09 by Jim Wilson: IEEE single-precision FLT_MIN value gets
# assembled incorrectly.  (Off by one ulp.)

proc dotest {} {
    set testname "IEEE FLT_MIN, single-precision"
    set x 0
    gas_start "x930509a.s" "-al"
    while 1 {
	expect {
	    -re " 00 ?00 ?80 ?00\[ 	\]+.single" { pass $testname; set x 1 }
	    -re " 00 ?80 ?00 ?00\[ 	\]+.single" { pass $testname; set x 1 }
	    -re ".single" { fail $testname; set x 1 }
	    -re "\[^\n\]*\n" { }
	    timeout { perror "timeout\n"; break }
	    eof { break }
	}
    }
    gas_finish

    # C54x alignment/addressing is different, so the listing looks different
    # float encoding is tested in c54x-specific tests.
    # No floating point support in assembly code for CRIS.
    setup_xfail "arc*-*-*" "cris-*-*" "*c30*-*-*" "*c54x*-*-*" "*c80*-*-*"
    setup_xfail "vax*-*-*" "crisv32-*-*"

    if !$x then { fail "$testname (listing didn't match)" }
}