// Copyright 2021 The Fuchsia Authors. All rights reserved.
// Use of this source code is governed by a BSD-style license that can be
// found in the LICENSE file.
library fuchsia.wlan.tap;

using fuchsia.wlan.common;
using fuchsia.wlan.device;
using fuchsia.wlan.ieee80211 as ieee80211;
using fuchsia.wlan.internal;
using zx;

/// Describes the capabilities of the fake wlantap-phy device to be created.
type WlantapPhyConfig = struct {
    // TODO(fxbug.dev/64628): wlantap will configure all of its ifaces to use the same MAC address
    sta_addr ieee80211.MacAddr;
    mac_role fuchsia.wlan.common.WlanMacRole;
    supported_phys
            vector<fuchsia.wlan.common.WlanPhyType>:fuchsia.wlan.common.MAX_SUPPORTED_PHY_TYPES;
    hardware_capability fuchsia.wlan.common.WlanSoftmacHardwareCapability;
    bands vector<fuchsia.wlan.device.BandInfo>:8;
    name string:32; // Arbitrary maximum size of 32 chosen to satisfy FidlLint
    quiet bool;
    discovery_support fuchsia.wlan.common.DiscoverySupport;
    mac_sublayer_support fuchsia.wlan.common.MacSublayerSupport;
    security_support fuchsia.wlan.common.SecuritySupport;
    spectrum_management_support fuchsia.wlan.common.SpectrumManagementSupport;
};

/// Instruct the wlantap-ctl device to creates a fake wlantap-phy device based on the
/// `WlantapPhyConfig` passed in. The newly created wlantap-phy device will use the channel to
/// allow a `WlantapPhy` client to observe and control its behavior.
protocol WlantapCtl {
    CreatePhy(resource struct {
        config WlantapPhyConfig;
        proxy server_end:WlantapPhy;
    }) -> (struct {
        status zx.status;
    });
};

/// Information pertaining to incoming packets. One WlanRxInfo is associated with each packet.
/// You are encouraged to use the default value in //src/connectivity/wlan/testing/hw-sim/src/lib.rs
/// See wlan_rx_info_t for details about each field.
type WlanRxInfo = struct {
    rx_flags uint32;
    valid_fields uint32;
    phy fuchsia.wlan.common.WlanPhyType;
    data_rate uint32;
    channel fuchsia.wlan.common.WlanChannel;
    mcs uint8;
    rssi_dbm int8;
    snr_dbh int16;
};

/// Instruction from generic WLAN driver on how to send a packet. One WlanTxInfo per packet.
/// These values are populated by the wlantap driver and should not be specified manually.
/// See wlan_tx_info_t for details about each field.
type WlanTxInfo = struct {
    tx_flags uint32;
    valid_fields uint32;
    tx_vector_idx uint16;
    phy fuchsia.wlan.common.WlanPhyType;
    cbw uint8;
    mcs uint8;
};

/// An outgoing packet that is to be "sent" by the wlantap device. `data` contains the packet
/// in its wire format.
type WlanTxPacket = struct {
    data vector<uint8>;
    info WlanTxInfo;
};

/// Configuration pertaining to security keys, often used by RSN and other secure authentication.
/// These values are populated by the wlantap driver and should not be specified manually.
/// See wlan_key_config_t for details about each field.
type WlanKeyConfig = struct {
    protection uint8;
    cipher_oui array<uint8, 3>;
    cipher_type uint8;
    key_type uint8;
    peer_addr ieee80211.MacAddr;
    key_idx uint8;
    key vector<uint8>:32;
};

/// Country code the device is to switch to.
/// These values are populated by the wlantap driver and should not be specified manually.
/// See also phy.fidl CountryCode.
type SetCountryArgs = struct {
    alpha2 array<uint8, 2>;
};

/// Allow the test program to observe and control the behavior of the wlantap-phy device.
/// A wlantap-phy device is a special vendor device and its driver (Fuchsia being the vendor)
/// used for testing purpose.
/// Implements a subset of `wlan_softmac_ifc_t` and `wlan_softmac_protocol_ops_t` defined in
/// fuchsia.hardware.wlan.softmac/mac.fidl
/// Implements a subset of `WlanphyImpl` protocol defined in
/// fuchsia.hardware.wlanphyimpl/wlanphy-impl.fidl
protocol WlantapPhy {
    /// Shutdown the phy device so that it does not respond to any further calls.
    /// Once shutdown, there is no way to restart the device.
    /// It can only be called at the end of a test.
    Shutdown() -> ();

    // wlan_softmac_ifc_t callbacks
    // simulating events happening at the devices side that are passed up to the driver.

    /// The device "receives" a frame "over the air" and pass it up to driver.
    Rx(struct {
        wlan_softmac_id uint16;
        data vector<uint8>;
        info WlanRxInfo;
    });
    /// The device report its status to the driver. (Not used).
    Status(struct {
        wlan_softmac_id uint16;
        st uint32;
    });
    /// For rate selection (Minstrel), the device's last frame transmission is a success/failure,
    /// with a certain number of retries.
    ReportTxStatus(struct {
        wlan_softmac_id uint16;
        txs fuchsia.wlan.common.WlanTxStatus;
    });

    // wlan_softmac_protocol_ops_t
    // events indicating that the wlan-softmac device received interface request calls from the driver.

    /// The device is to send a frame "over the air".
    -> Tx(struct {
        args TxArgs;
    });
    /// The device created by its parent device (wlantap-phy: wlanphy) is
    /// detected and being connected by wlanstack/wlancfg.
    /// The device is to enter the "running" state.
    -> WlanSoftmacStart(struct {
        args WlanSoftmacStartArgs;
    });
    /// The device is to switch to the specified channel.
    -> SetChannel(struct {
        args SetChannelArgs;
    });
    /// AP: The device is to use args.config as a template for beacon frames.
    /// Client: The device is to be configured with this BSS as it peer.
    -> ConfigureBss(struct {
        args ConfigureBssArgs;
    });

    // TODO: ConfigureBeacon

    /// The device is to install the keys (often coming from RSN, exceptions apply).
    -> SetKey(struct {
        args SetKeyArgs;
    });

    // WlantaphyImpl (defined in banjo)
    // events indicating that the wlanphy device received interface rquest calls from the driver.

    /// The device is to change its radio and power settings to conform to the regulation of the
    /// specified country.
    -> SetCountry(struct {
        args SetCountryArgs;
    });
};

type TxArgs = struct {
    wlan_softmac_id uint16;
    packet WlanTxPacket;
};

type SetChannelArgs = struct {
    wlan_softmac_id uint16;
    channel fuchsia.wlan.common.WlanChannel;
};

type ConfigureBssArgs = struct {
    wlan_softmac_id uint16;
    config fuchsia.wlan.internal.BssConfig;
};

type SetKeyArgs = struct {
    wlan_softmac_id uint16;
    config WlanKeyConfig;
};

type WlanSoftmacStartArgs = struct {
    wlan_softmac_id uint16;
};